Intro to Soldering

From MidsouthMakers - Memphis Area Hackerpace
Revision as of 22:20, 12 August 2010 by Dan9186 (talk | contribs) (→‎Components: updating to contain the other items needed)
Jump to navigation Jump to search
Intro to Soldering
Information
Location CBU


Overview

The purpose of this workshop is to educate individuals on how to solder by means of soldering together a predesignated circuit. This does not include the wiring of the circuit, but merely the soldering of the components into a board with the circuit already etched onto it. The circuit board will come from either the Intro to Etching workshop, or bought as a prefabbed board.

Components

Item Metric Cost/Item Qty Sub Total Distributor
Component Socket 28 Pin $0.30 1 $0.30 Mouser
Crystal Oscillator 16 MHz $0.55 1 $0.55 Mouser
Resistor 1 KOhm 1/4 Watt $0.05 1 $0.05 Mouser
Switch Momentary Push Switch $0.13 1 $0.13 Mouser
LM7805 5V Regulator $0.35 1 $0.35 Mouser
Ceramic Disk Capacitor 22 pF $0.06 2 $0.12 Mouser
Ceramic Disk Capacitor 0.01 uF or 10 nF $0.10 1 $0.10 Mouser
Electrolytic Capacitor 22 uF $0.02 1 $0.02 Mouser
ATMega328 Microcontroler 28Pin (Unbootloaded) $4.28 1 $4.28 Mouser
Multi Layer Ceramic Capacitor 0.1 uF $0.07 1 $0.07 Mouser
DC Power Connector 2.1 mm (Female) $1.29 1 $1.29 Mouser
Female Header 1x8 Pin $0.70 2 $1.40 DigiKey
Female Header 1x6 Pin $0.56 1 $0.56 DigiKey
Male Header 1x6 Pin $0.00 1 $0.00 Unknown
Male Header 2x3 Pin $0.00 1 $0.00 Unknown

Total: $8.52

Tools

Instructions

Circuit